SMC Networks TigerAccess SMC7816M - Manual (Page 743)

D
ISPLAYING
VDSL I
NFORMATION
29-61
Displaying VDSL Information
This section describes the commands used to display information on
VDSL configuration settings, signal status, and communication statistics.
Table 29-9 Commands for Displaying VDSL Information
Command Function Mode Page
Displaying Configuration Settings
show lre band-plan
Displays the frequency bands used for
VDSL signals PE 29-62
show lre
option-band Displays the frequencies to be used for the
optional US0 band PE 29-63
show lre ham-band Displays the HAM radio band that is
blocked to VDSL signals based on defined
frequencies PE 29-64
show lre
region-ham-band Displays the HAM radio band that is
blocked to VDSL signals based on defined
usage types PE 29-65
show lre psd Displays the power level set for each of the
PSD breakpoints PE 29-67
show lre
psd-mask-level Displays the predefined PSD mask
configured for an interface PE 29-68
show lre pbo-config Displays the mask used to reduce the power
spectral density (PSD) of transmitted signals
at specified frequency breakpoints
PE 29-69
show lre upbo Shows if upstream power backoff is enabled
or disabled PE 29-70
show lre tone Shows if VDSL signals are enabled or
disabled at frequencies less than or equal to
640 KHz, 1.1 MHz or 2.2 MHz PE 29-71
show lre
interleave-max-delay Displays the maximum interleave-delay for
downstream and upstream channels PE 29-72
show lre datarate Displays the minimum and maximum data
rate for downstream and upstream fast or
slow (interleaved) channels PE 29-73