Packet filtering commands, Filter ipmac, Packet filtering commands -5 – SMC Networks TigerAccess SMC7816M User Manual
Page 593: Filter ipmac -5, Table 23-3 packet filter commands -5
P
ACKET
F
ILTERING
C
OMMANDS
23-5
Packet Filtering Commands
This section describes commands used to configure packet filtering for
inbound traffic.
Note: Packet Filtering occupies valuable hardware resources. Using
Private VLANs provides a more efficient alternative for separating
the traffic sent to each subscriber (see “Configuring Private
VLANs” on page 32-17).
filter ipmac
This command filters packets matching the specified source MAC and IP
address.
Syntax
filter ipmac add interface MAC-address IP-address
filter ipmac del interface [MAC-address [IP-address]]
• add - Adds a MAC and IP address pair to filter.
• del - Deletes all filtering entries, or an entry for a MAC and IP
address pair.
• interface
- unit - Stack unit. (Range: 1)
- port-list - Single port number or list of ports. (Range: 1-18)
• MAC-address - Physical address of source.
• IP-address - IP address of source.
Table 23-3 Packet Filter Commands
Command
Function
Mode Page
filter ipmac
Filters packets matching specified MAC address
and IP address
GC
filter netbios
Filters NetBIOS packets
GC
filter
dhcp-request
Filters DHCP request packets
GC
filter dhcp
Filters DHCP reply packets
GC
show filter
Displays packet filter settings
PE