SMC Networks TigerAccess SMC7816M - Manual (Page 723)

L
INE
P
ROFILE
C
OMMANDS
29-41
region-ham-band
This command sets the ham radio band that will be blocked to VDSL
signals based on defined usage types. Use the no form to restore the
default status.
Syntax
region-ham-band value
no region-ham-band
value – HAM band mask for designated usage type.
(See Table 29-5, “HAM Band Notches for Usage Types,” on
page 29-10.)
Default Setting
36 (none)
Command Mode
VDSL Line Profile
Command Usage
Using a HAM band mask prevents interference with other systems (e.g.,
amateur radio) that use narrow band transmission in the VDSL
frequency band. The selected frequency range will not be used to
transmit data on the VDSL line. You may need to specify a mask if
required by local regulations or if specific incidents of interference are
reported within a service area.
Example
This example sets a HAM band notch in the transmitted power spectrum
to avoid interference with CB radios.
Related Commands
ham-band (29-40)
lre region-ham-band (29-9)
Console(config-line-profile)#region-ham-band 34
Console(config-line-profile)#