SMC Networks TigerAccess SMC7816M - Manual (Page 809)

32-1
C
HAPTER
32
VLAN C
OMMANDS
A VLAN is a group of ports that can be located anywhere in the network,
but communicate as though they belong to the same physical segment.
This section describes commands used to create VLAN groups, add port
members, specify how VLAN tagging is used, and enable automatic
VLAN registration for the selected interface.
Table 32-1 VLAN Commands
Command Groups Function Page
GVRP and
Bridge Extension Configures GVRP settings that permit automatic
VLAN learning; shows the configuration for
bridge extension MIB 32-2
Editing VLAN Groups Sets up VLAN groups, including name, VID and
state
32-7
Configuring VLAN
Interfaces Configures VLAN interface parameters,
including ingress and egress tagging mode,
ingress filtering, PVID, and GVRP 32-9
Displaying VLAN
Information Displays VLAN groups, status, port members,
and MAC addresses 32-16
Configuring Private
VLANs Configures private VLANs, including uplink and
downlink ports 32-17
Configuring Protocol
VLANs Configures protocol-based VLANs based on
frame type and protocol 32-20
Configuring 802.1Q
Tunneling
*
* These functions are not compatible.
Configures IEEE 802.1Q tunneling (QinQ) to
segregate and preserve customer VLAN IDs for
traffic crossing the service provider network 32-25
Configuring VLAN
Swapping
*
Maps VLAN ID between customer and service
provider for networks that do not support IEEE
802.1Q tunneling 32-30