SMC Networks TigerAccess SMC7816M - Manual (Page 871)

POLICE
34-9
police command to limit the average bandwidth to 100,000 Kbps, the
burst rate to 1522 bytes, and configure the response to drop any violating
packets.
police
This command defines an policer for classified traffic. Use the no form to
remove a policer.
Syntax
[no] police rate-kbps burst-byte [exceed-action {drop | set}]
• rate-kbps - Rate in kilobits per second. (Range: 1-100000 kbps or
maximum port speed, whichever is lower)
• burst-byte - Burst in bytes. (Range: 64-1522 bytes)
• drop - Drop packet when specified rate or burst are exceeded.
• set - Set DSCP service to the specified value. (Range: 0-63)
Default Setting
Drop out-of-profile packets.
Command Mode
Policy Map Class Configuration
Command Usage
• You can configure up to 63 policers (i.e., class maps) for Fast Ethernet
and Gigabit Ethernet ingress ports.
• Policing is based on a token bucket, where bucket depth (i.e., the
maximum burst before the bucket overflows) is by specified the
burst-byte field, and the average rate tokens are removed from the
bucket is by specified by the rate-bps option.
Console(config)#policy-map rd_policy
Console(config-pmap)#class rd_class
Console(config-pmap-c)#set ip dscp 3
Console(config-pmap-c)#police 100000 1522 exceed-action drop
Console(config-pmap-c)#