SMC Networks TigerAccess SMC7816M - Manual (Page 371)

L
AYER
2 Q
UEUE
S
ETTINGS
14-5
Web – Click Priority, Traffic Classes. Assign priorities to the traffic classes
(i.e., output queues), then click Apply.
Figure 14-2 Traffic Classes
CLI – The following example shows how to change the CoS assignments
to a one-to-one mapping.
* Mapping specific values for CoS priorities is implemented as an interface
configuration command, but any changes will apply to the all interfaces on the
switch.
Console(config)#interface ethernet 1/1 25-2
Console(config)#queue cos-map 0 0 33-8
Console(config)#queue cos-map 1 1
Console(config)#queue cos-map 2 2
Console(config)#exit
Console#show queue cos-map
33-10
Information of Eth 1/1
CoS Value: 0 1 2 3 4 5 6 7
Priority Queue: 0 1 2 3 4 5 6 7
Information of Eth 1/2
CoS Value: 0 1 2 3 4 5 6 7
Priority Queue: 0 1 2 3 4 5 6 7
.
.
.