SMC Networks TigerAccess SMC7816M - Manual (Page 740)

VDSL C
OMMANDS
29-58
Example
The following sets the LOSs threshold to 15.
thresh-15min-lprs
This command sets the threshold for Loss of Power Seconds (LPRs) that
can occur within any given 15 minutes. Use the no form to restore the
default setting.
Syntax
thresh-15min-lprs value
value – Threshold for Loss of Power Seconds.
(Range: 0-900 seconds; 0 disables the threshold)
Default Setting
10
Command Mode
VDSL Alarm Profile
Command Usage
This command sets the threshold for the number of loss of power
seconds within any 15 minute collection interval for performance data.
If the number of loss of power seconds in a particular 15-minute
collection interval reaches or exceeds this value, a
vdslPerfLprsThreshNotification notification will be generated. (Refer to
RFC 3728 for information on this notification message.) No more than
one notification will be sent per interval.
Example
The following sets the LPRs threshold to 15.
Console(config-alarm-profile)#thresh-15min-loss 15
Console(config-alarm-profile)#
Console(config-alarm-profile)#thresh-15min-lprs 15
Console(config-alarm-profile)#