SMC Networks TigerAccess SMC7816M - Manual (Page 613)

DHCP S
NOOPING
C
OMMANDS
23-25
• Additional considerations when the switch itself is a DHCP client – The port(s)
through which it submits a client request to the DHCP server must be
configured as trusted.
Example
This example sets port 5 to untrusted.
Related Commands
ip dhcp snooping (23-18)
ip dhcp snooping vlan (23-20)
show ip dhcp snooping
This command shows the DHCP snooping configuration settings.
Command Mode
Privileged Exec
Example
Console(config)#interface ethernet 1/5
Console(config-if)#no ip dhcp snooping trust
Console(config-if)#
Console#show ip dhcp snooping
Global DHCP Snooping status: enable
DHCP Snooping is configured on the following VLANs:
1,
Verify Source Mac-Address: enable
Service Provider Mode: disable
Interface Trusted Client-limit
---------- ---------- ------------
Eth 1/1 No 5
Eth 1/2 No 5
Eth 1/3 No 5
Eth 1/4 No 5
Eth 1/5 Yes 5
.
.
.