SMC Networks TigerAccess SMC7816M - Manual (Page 929)

B
ASIC
IP C
ONFIGURATION
38-3
Notes: 1. Only one VLAN interface can be assigned an IP address (the
default is VLAN 1). This defines the management VLAN, the
only VLAN through which you can gain management access to
the switch. If you assign an IP address to any other VLAN, the
new IP address overrides the original IP address and this
becomes the new management VLAN.
2. Before you can change the IP address, you must first clear the
current address with the no form of this command.
Example
In the following example, the device is assigned an address in VLAN 1.
ip default-gateway
This command specifies the IP default gateway for destinations not found
in the local routing tables. Use the no form to remove a default gateway.
Syntax
ip default-gateway gateway
no ip default-gateway
gateway - IP address of the default gateway
Default Setting
No static route is established.
Command Mode
Global Configuration
Command Usage
• A gateway must be defined if the management station is located in a
different IP segment.
• An default gateway can only be successfully set when a network
interface that directly connects to the gateway has been configured on
the switch.
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.5 255.255.255.0
Console(config-if)#