SMC Networks TigerAccess SMC7816M - Manual (Page 684)

VDSL C
OMMANDS
29-2
Long-Reach Ethernet Commands
This section describes how to configure communication parameters for
VDSL ports such as specifying data band usage plans, setting notches
within the frequency bands to avoid interference with ham radio signals,
setting a mask for power spectral density to meet regional or local
limitations for transmitting signals on phone lines, setting an acceptable
target for the signal-to-noise ratio, and enabling automatic rate adaptation.
Table 29-2 Long-Reach Ethernet Commands
Command Function Mode Page
lre band-plan Sets the frequency bands used for VDSL
signals IC 29-4
lre option-band Sets the frequencies to be used for the
optional US0 band. GC/IC 29-6
lre ham-band Sets the HAM radio band that will be
blocked to VDSL signals based on
defined frequencies GC/IC 29-7
lre region-ham-band Sets the HAM radio band that will be
blocked to VDSL signals based on
defined usage types
GC/IC 29-9
lre psd-breakpoints Sets the number of frequency breakpoints
in the PSD mask GC/IC 29-12
lre psd-frequencies Maps a frequency to each breakpoint in
the PSD mask GC/IC 29-13
lre psd-value Defines a power level for each of the PSD
breakpoints GC/IC 29-15
lre psd-mask-level Sets a predefined PSD mask GC/IC 29-16
lre pbo-config Sets a mask to reduce the power spectral
density (PSD) of transmitted signals at
specified frequency breakpoints GC 29-18
lre upbo Enables upstream power backoff GC/IC 29-19
lre tone Disables VDSL signals at frequencies less
than or equal to 640 KHz, 1.1 MHz or 2.2
MHz GC/IC 29-21