SMC Networks TigerAccess SMC7816M - Manual (Page 899)

M
ULTICAST
VLAN R
EGISTRATION
C
OMMANDS
35-23
Multicast VLAN Registration Commands
This section describes commands used to configure Multicast VLAN
Registration (MVR). A single network-wide VLAN can be used to transmit
multicast traffic (such as television channels) across a service provider’s
network. Any multicast traffic entering an MVR VLAN is sent to all
subscribers. This can significantly reduce to processing overhead required
to dynamically monitor and establish the distribution tree for a normal
multicast VLAN. Also note that MVR maintains the user isolation and data
security provided by VLAN segregation by passing only multicast traffic
into other VLANs to which the subscribers belong.
Table 35-6 Multicast VLAN Registration Commands
Command Function Mode Page
mvr Globally enables MVR, statically configures MVR
group address(es), or specifies the MVR VLAN
identifier GC 35-24
mvr Configures an interface as an MVR receiver or
source port, or configures an interface as a static
member of the MVR VLAN IC 35-26
mvr
immediate Enables immediate leave capability IC
show mvr Shows information about the global MVR
configuration settings, the interfaces attached to the
MVR VLAN, or the multicast groups assigned to
the MVR VLAN PE 35-29