SMC Networks TigerAccess SMC7816M - Manual (Page 869)

CLASS
34-7
class
This command defines a traffic classification upon which a policy can act,
and enters Policy Map Class configuration mode. Use the no form to
delete a class map and return to Policy Map configuration mode.
Syntax
[no] class class-map-name
class-map-name - Name of the class map. (Range: 1-16 characters)
Default Setting
None
Command Mode
Policy Map Configuration
Command Usage
• Use the policy-map command to specify a policy map and enter
Policy Map configuration mode. Then use the class command to
enter Policy Map Class configuration mode. And finally, use the set
and police commands to specify the match criteria, where the:
- set command classifies the service that an IP packet will receive.
- police command defines the maximum throughput, burst rate,
and the action that results from a policy violation.
• You may only configure one rule per Class Map, but you can assign
one or more classes to a policy map.