SMC Networks TigerAccess SMC7816M - Manual (Page 718)

VDSL C
OMMANDS
29-36
line-profile
This command enters VDSL Line Profile configuration mode.
Syntax
line-profile profile-name
profile-name – Name of the profile. (Range: 1-31 alphanumeric
characters)
Command Mode
Global Configuration
Command Usage
All commands entered in this mode are stored under the named profile,
and take effect only when this profile is applied to a set of VDSL ports.
down-fast-max-datarate
down-fast-min-datarate
up-fast-max-datarate
up-fast-min-datarate
down-slow-max-datarate
down-slow-min-datarate
up-slow-max-datarate
up-slow-min-datarate Sets maximum/minimum data rate on
a fast/slow downstream/upstream
channel VLP 29-47
down-target-noise-mgn
up-target-noise-mgn Sets the targeted signal-to-noise margin
that VDSL ports must achieve to
successfully complete initialization on a
downstream/upstream channel VLP 29-48
down-min-noise-mgn
up-min-noise-mgn Sets the minimum acceptable
signal-to-noise margin on a
downstream/upstream channel VLP 29-49
* VDSL Line Profile configuration mode.
Table 29-7 Line Profile Commands
Command Function Mode Page