Receiver is not tracking satellites – Spectra Precision ProMark 800 Reference Manual User Manual

Page 110

Advertising
background image

98

Troubleshooting

Receiver is Not Tracking Satellites

202 Medium Invalid link speed

You are trying to set a baud rate that is not appropriate. Find which
baud rate should be used and try again.

203 Medium Invalid FEC mode

You are trying to set a FEC mode that is not appropriate. Check that
you are asking for a valid one.

204 Medium

Too many config files
(*.par)

The receiver is trying to use a configuration file but does not know
which one to use. Make sure there’s only one file available and it is the
one you want the receiver to use.

205 Medium

Invalid registration code =>
No registration code

No registration code entered for the receiver. Contact Technical Sup-
port.

206 Medium

Invalid registration code =>
Bad registration code

The receiver detects an incorrect registration code. Contact Technical
Support.

207 Medium

Invalid Position => Position
from $PASHS,POS

The receiver detects an incorrect position assigned to its location. Use
$PASHS,POS to enter the right position.

208 Medium GSM already in FTP mode

You are trying to assign a function to the modem while it’s already
used in a network connection using the FTP protocol. See what you
want the modem to do and then take the necessary steps to use it as
desired.

209 Medium

ADL Radio Power is
reduced

The receiver detects that the radiated power level set in the radio used
was intentionally lowered. This is because the radio is powered from
the internal battery, not from an external power source.

210 Medium

Radio Protocol not sup-
ported

You are trying to set a protocol that does not match the type of radio
used. Choose a suitable protocol and try again.

213 Medium

Bad Base Position => In
Rover mode, base position
received

The receiver detects a bad base position received from the base.
Check base position and correct it at the base.

214 Medium

Bad Base Position => In
Base mode, base position
sent

The receiver detects a bad base position assigned to the base. Check
base position and correct it.

215 Medium GNSS in Boot mode

Contact Technical Support.

216 Medium ANP forbidden if HDB OFF

You are trying to enter a user-defined antenna while HDB is off. Set
HDB to on and try again.

217 Medium RCP forbidden if HDB OFF

You are trying to enter a user-defined antenna while HDB is off. Set
HDB to on and try again.

218 Medium Corrupted USB

A corrupted directory (“Found.*”) has been detected on the USB. The
key can still be used out of this directory. Re-formatting should be envi-
sioned.

219 Medium USB directory overflow

One directory has more than 500 files. The USB key is unmounted
automatically..

#

Rank

Alarm Label

Symptoms & Remedies

RTK Base

RTK Rover

PP Base

PP Rover

Relevant to

Advertising