Spectra Precision ProMark 800 Reference Manual - Manual (Page 374)

362
Query Command Library
RWO: Raw Data Output Settings
Function This command is used to query the raw data output
parameters on the specified port.
Command Format Syntax
$PASHQ,RWO,c[*cc]
Parameters
Response Format Syntax
$PASHR,RWO,c1,d2,f3,d4,n(s5,f6,c7)*cc
Where n=8
Parameters
Parameter Description Range
c Port ID the command refers to A, C, M, U
*cc Optional checksum *00-*FF
Parameter Description Range
c1
The port ID specified in the command is
reminded in this field:
• A: Serial port
• C: Bluetooth port
• M, U: Memory
A, C, M, U
d2
Baud rate code for serial port.
For other devices, “0” if not available, else
“1” 0-9 (A). See table
below
0-1 (C, M, U)
f3
Output rate defined by the last
$PASHS,RAW,PER command run
0-999.9
d4 Number of raw data messages 11
s5 Raw data message types
MPC, DPC, PBN,
SNV, SNG, SNW,
SAL, SAG, SAW,
ION, SBD
f6
Output rate
0: Message disabled
0-999.00
c7 ASCII/Binary setting. Always binary B
*cc Checksum *00-*FF
Code Baud Rate Code Baud Rate
0 300 5 9600
1 600 6 19200
2 1200 7 38400
3 2400 8 57600