Rockwell Automation 1398-PDM-xxx IQ Master Version 3.2.4 for IA-2000 and IQ-5000 Positioning Drive Modules, IQ-55 - Manual (Page 60)

38 Parameter Menu • Compile Options
Publication 1398-PM601A-EN-P — October 2000
MENUS
Parameter Menu
The Parameter menu contains the parameter values used to control the ULTRA Plus or IQ system. The
values are stored in a parameter table in nonvolatile RAM (NVRAM). All parameters should be
reviewed, entered or changed based on the application. The parameters in the table are used unless over-
ridden locally in a program. If a program does override parameters, the values in the parameter table are
used once again when the program is stopped.
To Access Parameter Menu Items
• Select the Parameter menu by clicking on Parameter in the menu bar,
-or-
press ALT to activate the menu bar, then P to pull down the Parameter menu.
• Select the menu item by clicking on your selection,
-or-
pressing the letter that is underlined in your selection (for example the “O” in Outputs),
-or-
using the arrow keys to highlight your selection and then press ENTER.