Freescale Semiconductor ColdFire MCF52210 - Manual (Page 31)

Signal Descriptions
MCF52211 ColdFire® Integrated Microcontroller Reference Manual, Rev. 2
Freescale Semiconductor 2-1
Chapter 2
Signal Descriptions
2.1 Introduction
This chapter describes signals implemented on this device and includes an alphabetical listing of signals
that characterizes each signal as an input or output, defines its state at reset, and identifies whether a
pull-up resistor should be used.
NOTE
The terms assertion and negation are used to avoid confusion when dealing
with a mixture of active-low and active-high signals. The term asserted
indicates that a signal is active, independent of the voltage level. The term
negated indicates that a signal is inactive.
Active-low signals, such as SRAS and TA, are indicated with an overbar.
2.2 Overview
Figure 2-1 shows the block diagram of the device with the signal interface.