ZOLL M Series Defibrillator Rev R - Manual (Page 103)

M Series Service Manual
93
Step 5: Lift the SpO
2
module straight up from the
foam and disconnect the ribbon cable from the
Isolated Power Supply.
Step 6: (Biphasic units only) Disconnect the
biphasic defibrillator capacitor from the rear
panel connector.
Step 7: (Biphasic units only) Disconnect the
Molex connector from the biphasic module. Step 8: (EtCO
2
units only) Remove the EtCO
2
connector by gently lifting the connector away
from the back panel. To remove the EtCO
2
and
isolated power supply, refer to Step 5.
Biphasic
defibrillator
capacitor
Molex
connector
Biphasic
module
EtCO
2
connector