Removing the system board assembly – ZOLL M Series Defibrillator Rev R User Manual
Page 97
Advertising
M Series Service Manual
87
4. Removing
the
System
Board
Assembly
Tools Required
• #1 and #2 Phillips Screwdriver
• Grounding Mat
• Grounding Wrist Strap
• Needle Nose Pliers
• Orange Stick
WARNING! You can damage the hardware of
the unit. You must use ESD grounding before
you handle any printed circuit boards on the
unit.
Setup
Before you begin this procedure, make sure you
are grounded.
1. Know or review 1.0 Removing the ZIF
Keeper procedure.
2. Remove the Front Panel Assembly.
3. Remove the Upper Housing Assembly.
To reinstall the System Board Assembly, reverse the steps.
Advertising