Required equipment, Parts that may need replacing after disassembly – ZOLL M Series Defibrillator Rev R User Manual
Page 86
M Series Service Manual
76
• 13. Removing the PCMCIA Card Slot Assembly
• 14. Removing the Paddle Release Latch
Required Equipment
• No. 1 Phillips screwdriver.
• No. 2 Phillips screwdriver.
• Exacto-knife.
• Orange wooden stick. (Available from H.A. Stiles: 1-800-447-8537)
• 90° dental pick.
• Needle nose pliers.
• Kapton tape.
• 3M copper adhesive tape, or equivalent.
• 1/2” nut driver.
• Large diagonal cutters.
• Strong glue, such as Loctite 420 or equivalent.
• Loctite needle tip dispenser.
Parts That May Need Replacing After Disassembly
If you are removing the Control Board from the Front Panel, you need to have:
• Main Selector knob replacement (ZOLL Part Number 9310-0521)
• Pacer/Output/Rate knob replacement (ZOLL Part Number 9310-0520)
If you are removing the Battery Interconnect Board, you may need to replace it with a new one, using ZOLL Part
Number 9301-0302, if connectors have been UV welded as in older M Series models.