Buhler 2180 - Manual (Page 103)

SECTION 2 - OPERATION
2-57
TRANSMISSION PROGRAMMING
PROGRAMMING THE PROGRAMMABLE
UP SHIFT, DOWN SHIFT
To change the number of gears increased or
decreased when selecting the programmable up
shift or down shift, proceed as follows:
• Turn the KEY-START switch off.
• Move the control lever to the reverse speed
position, then hold the lever to the left.
• While holding the lever to the left, turn on the
KEY-START switch (but do not start the engine.)
After three seconds, the digital display should
show “U-d” indicating the up/down shift program-
ming mode is engaged.
• Return the control lever to the reverse position.
89
To program the up shift:
• With the shift lever still in reverse, move the lever
to the right and hold for three seconds. The digital
display will show an up arrow and the up shift
number currently stored in memory.
• Move and release the lever to the right one, two
or three times, as required. The display will show
“1”, “2” or “3.” This indicates that when the UP
SHIFT switch is depressed, the transmission will
up shift one, two or three gears higher than the
gear currently being used. To cancel the Up Shift
program, move and release the lever to the left
until “0” appears.
• Return the lever to neutral after selecting the
desired up shift to store the program.
To program the down shift:
• To change the number of gears that will be down
shifted when Down Shift is selected, position the
shift lever in neutral. The display should show
“U-d.” Move the shift lever to reverse position
then to the left and hold for three seconds. The
display will show a down arrow and the down shift
number currently stored in memory.
• Move and release the lever to the right one, two
or three times and the display will show “1”, “2” or
“3”. This indicates the number of gears that will
be down shifted from the current gear when the
DOWN SHIFT switch is activated. To cancel the
down shift program, move and release the lever
to the left until “0” appears.
• Return the lever to neutral after selecting the
desired down shift to store the program.
To exit the program:
• Turn the key-switch to the off position to exit the
up shift and down shift program mode.
90