Buhler 2180 - Manual (Page 144)

SECTION 2 - OPERATION
2-98
WARNING
Before using the external 3-point hitch control
switches, ensure that no person or object is in
the area of the implement or three-point linkage.
Never operate the external switches while
standing:
•
Directly behind the tractor
• Between the lower links
• On or near the implement.
Only operate switches while standing in the
hatched areas, 2, as shown in Figure 140.
Never extend arms, legs, any part of the body or
any object into the area near the three-point
linkage or implement while operating the
external switch.
Never have an assistant working the opposite set
of controls. When moving to the opposite set of
controls, move around the tractor or implement.
Do not cross between the implement and tractor.
To transfer control of the 3-point hitch back to the lift
control lever:
1. Cycle the FAST RAISE/WORK switch, 1, to the
fast raise position (rear), then to the work position
(forward).
2. Push the lift control lever fully forward then pull
the lever slowly rearwards to capture the hitch.
3. The hitch enabled symbol, 3, Figure 127, will
display, indicating that the three-point linkage is
in phase with the lift control lever.
144