Buhler 2180 - Manual (Page 88)

SECTION 2 - OPERATION
2-42
SINGLE PIN AUXILIARY CONNECTOR
A 12-volt single pin power connector, 1, is located at
the right rear of the cab. The connector has an 8-amp
rating to power electrical monitoring equipment. The
connector is activated by the KEY-START switch.
The mating single pin connector P/N 86508819 may
be purchased from your Buhler Versatile dealer.
THREE PIN AUXILIARY MATING
CONNECTOR
A 12-volt, three pin connector, 2, is installed to allow
the attachment and operation of electronic control
boxes.
Terminal, 3, is controlled by the key switch. This
terminal has a 30-amp rating.
Terminal, 4, is powered continually. This terminal has
an 8-amp rating.
Terminal, 5, is ground.
The mating male three pin connector P/N 86032122
may be obtained from your Buhler Versatile Dealer.
67
MONITOR MOUNT -- AUXILIARY POWER
BAR KIT (P/N 86030509)
This kit provides additional power sources for cab
mounted monitors.
Terminal, 3, is controlled by the key switch. This
terminal has a 15-amp rating.
Terminal, 4, is powered continually. This terminal has
an 15-amp rating.
Terminal, 5, is ground.
68