Buhler 2180 - Manual (Page 89)

SECTION 2 - OPERATION
2-43
AUXILIARY CONTROL MOUNTING
LOCATIONS
Two 10 mm cap screws, 2, are located in the right
rear panel for attaching an equipment monitor or
control box.
An alternate mounting position is provided on the
inner face of the right front “A” post, 1.
NOTE: When installing two-way communication
radios:
1. Install the radio on the left side of the cab.
2. Route the co-axial cable out the left side of the
cab.
3. Mount the antenna on a ground plane on the roof.
4. Make sure the antenna is grounded.
2
1
69
AUXILIARY CONTROL CABLE ROUTING
Two locations are provided for routing the operating
cables from the control box to the attachment.
Rear Window Grommet
A rubber grommet, 1, is provided to allow equipment
control cables, 2, to pass through the rear window
frame, 3.
Pull the grommet plug, 1, up to remove. Slit the
grommet plug from the bottom into the hollow center,
4. Route implement controls through the grommet
plug, then reinstall the grommet plug.
1
2
3
4
70
Removable Panel
A removable panel, 1, is located below the rear
window. Remove the panel to access the opening in
the rear cab wall. Route the controls through the
opening. Store the panel and attaching hardware for
future use.
1
71