Buhler 2180 User Manual
Page 65
SECTION 2 - OPERATION
2-19
19. Parking Brake
With the KEY-START switch on, a continually
illuminated parking brake lamp, 19, indicates that the
parking brake is applied. If the gearshift lever is
moved from neutral to a gear position with the
parking brake applied, the alarm will sound, the
transmission will be disabled and a “P” operator
prompt will flash in the gear display. To drive the
tractor, move the shift lever to neutral, apply the foot
brake, release the parking brake and select a
transmission gear.
If the KEY-START switch is turned off, and the
parking brake is not applied, a pulsating alarm will
sound continuously in unison with the flashing
parking brake lamp, 19, for approximately two
minutes or until the parking brake is applied,
whichever occurs first.
If the operator leaves the seat with the engine
running and gear shift in neutral, the parking brake
pulsating audible alarm will signal in unison with the
flashing parking brake lamp for 2 minutes or until the
brake is applied.
WARNING
To avoid personal injury, always apply the
parking brake before leaving the tractor seat.
20. System Status
The System Status lamp, 20, is illuminated when all
systems are normal. It flashes when a malfunction is
detected in a system monitored by the warning lamps
or bar graphs.
21. Headlight High Beam
The High Beam lamp, 21, will illuminate when the
tractor lights are switched to high beam.
28