Buhler 2180 - Manual (Page 69)

SECTION 2 - OPERATION
2-23
TRANSMISSION GEAR SHIFT POSITION
DISPLAY
The upper LCD, 1, provides a display of the gear
selected.
The left position, 2, displays a letter as follows:
F - Forward gear selected*
N - Neutral selected
R - Reverse gear selected*
C - Creeper gear speeds selected (if equipped)
A - Automatic shift selected
P - Parking brake applied*
U - Upshift selected*
d - Down shift selected*
The right digit(s), 3, display gear 1-16.
*If the letter is flashing, the display is indicating an
“Operator Prompt” where the park brake is
inappropriately on or off or out of sequence with the
transmission control lever. To return to normal
operation, release or apply the park brake as
appropriate. Return the transmission control lever to
neutral, release the park brake, then shift to either
forward or reverse as desired.
The right position, 3, represents the gear selected.
32
ENGINE SPEED - DIGITAL DISPLAY
With the engine running, the digital value, 1, of the
engine RPM will be displayed, together with the RPM
legend, 2, in the center LCD.
The engine LCD will register in increments of 10
RPM.
If a critical engine or driveline fault should occur, the
word “STOP” will flash for 30 seconds in the display
area and the engine will shut down automatically.
33