Buhler 2180 - Manual (Page 77)

SECTION 2 - OPERATION
2-31
EIC PROGRAMMING
OPERATOR CALIBRATION
In order that the modules may correctly calculate and
display work done (area per hour, area accumulated,
etc.) various factors must be entered into the
modules. To enter the set up mode, turn the key-start
switch on and hold down the SET UP/SELECT
switch, 2, for three seconds until a “beep” is heard.
44
The TPM display will indicate __ __ __ 1, which
means the EIC is in the first of 12 programming and
diagnostic modes. Touching the DIGIT SET switch,
4, Figure 44, will cycle through modes 1 - 12. Mode,
1, is for operator calibrations. Modes 2 - 12, are
discussed in the Service Manual.
To enter Mode 1, hold the SET UP/SELECT switch,
1, for three seconds. The TPM display will show IMP.
WIDTH CAL and a flashing left-hand digit.
When in the set up mode, repeatedly touching the
SET UP/SELECT switch, 1, will cause the modules
to run through the various set up functions in the
following order:
1. Implement width
2. Slip alarm point (option)
3. Service Alert Indicator I
4. Service Alert Indicator II
5. Ground speed calibration
6. Area Preset
7. Fault code display - ON/OFF
8. Three Point Hitch position -- Area Counter
45