Buhler 2180 - Manual (Page 41)

SECTION 1 - GENERAL INFORMATION
1-23
15. 3-POINT HITCH RATE OF DROP CONTROL
(if equipped)
The rate of drop control is provided to limit the rate of
drop of the 3-point linkage.
Rotate knob, 15, clockwise for faster drop rate and
counterclockwise for slower drop speeds. See
“3-Point Hitch Controls” for details.
16. 3-POINT HITCH HEIGHT LIMIT CONTROL
(if equipped)
The height limit control limits the maximum height to
which the lift arms can be raised to prevent large
implements from striking the rear of the cab.
Rotate knob, 16, clockwise to increase hitch height.
See “3-Point Hitch Controls” for details.
17. SLIP CONTROL (if equipped)
This control is only available when the tractor is
equipped with the optional radar sensor unit.
When used in conjunction with the 3-point hitch, the
slip control limits the amount of rear wheel slip.
Rotate knob, 17, to indicate the slip rate above which
override should occur. The 3-point hitch will raise
until the percent of slip drops below the override
setting, then the hitch will return to its original
position. See “3-Point Hitch Controls” for details.
When used in drawbar applications, the knob may be
set to the maximum allowable slip. If the slip limit is
exceeded, the light, 17A will illuminate. A slip alarm
may also be programmed to occur (See EIC tractor
performance monitor (TPM) section).
17a. WHEEL SLIP INDICATOR LIGHT (IF
EQUIPPED)
The wheel slip indicator light, 17a will be illuminated
whenever the wheel slip exceeds the preset value.
This light is present when the tractor is equipped with
the slip control option.
12
13
14
15
16
17
19
18
20
17a
37