Buhler 2180 - Manual (Page 85)

SECTION 2 - OPERATION
2-39
LIGHTS AND ACCESSORY POWER POINTS
MASTER LIGHT SWITCH
Lights are controlled by the four position MASTER
LIGHT switch, 1, as follows:
A Full counterclockwise is off
*B Parking lights on
*C Headlights and parking lights on
*D Work lights, headlights and parking lights on.
The work lights are selected by using the
touch-sensitive switches, 2, on the electronic
instrument cluster (EIC).
* Monitor lamp, 7, will be on in these positions.
The MASTER LIGHT switch will turn all work lights
off. When the master switch is again turned to the
work lights position, the same work lights will be
illuminated.
If the light switch is in any position other than off when
the key is turned off, a five second audible alert will
be activated. Turn the light switch off to cancel the
alert.
WORK LIGHTS
Reference the work light selector switches, 2, and
monitor, 3:
To operate the lower front and side work lights, 2,
Figure 64, touch selector switch, 1. The indicator
lights will illuminate at lower position 1 on the monitor
to indicate the lights are activated.
To operate the lower rear work lights, 3, Figure 65,
touch selector switch, 2. The indicator light will
illuminate at position 2 on the monitor to indicate the
lights are activated.
NOTE: A remote work lamp can also be activated
with switch, 2, using the seven pin auxiliary trailer
connector pin 7, Figure 67.
To operate the upper rear work lights, 4, Figure 65,
touch selector switch, 3. The indicator light will
illuminate at position 3 on the monitor to indicate the
lights are activated.
NOTE: If the hazard lights are on, the rear work lights
will automatically be turned off.
To operate the optional upper front work lights, 4,
Figure 64, touch selector switch, 4. The indicator light
will illuminate at position 4 on the monitor to indicate
the lights are activated.
Touch any switch a second time to turn the respective
lights off.
61
PANEL DIM CONTROL
Dimmer control, 4, can be activated with the master
lights on or off. Touch the DIMMER switch, 4, and the
instrument console back lights will go from bright to
dim. Hold the switch and the lights will dim to
whatever level the operator requires.
Touch the switch again to select bright.
ROTARY BEACON
Available from Buhler Versatile Parts
Push the top of the switch, 5, to actuate the rotary
beacon. The top of the switch is illuminated when on.
Push the bottom of the switch to turn the beacon off.
HAZARD WARNING LIGHTS
The switch, 6, is internally illuminated and, when
actuated by pushing the top of the switch, will flash
in unison with all the tractor and trailer turn signals
and the green indicator lamps in the EIC.
Push the bottom of the switch to turn off the hazard
lights.
NOTE: When a turn signal is activated, the activated
lights will flash, indicating a turn, while the lights on
the other side of the tractor will be lighted
continuously. For your protection, use the hazard
warning lights when traveling on public roads unless
prohibited by law.