Buhler 2180 - Manual (Page 158)

SECTION 2 - OPERATION
2-112
FRONT WHEEL TRACK SPACING
168
INTRODUCTION
NOTE: Read this section completely before
adjusting track width.
NOTE: The track width dimensions (width from
center to center) shown may vary from your actual
measurements depending on specific wheel and tire
combination and tire manufacturer.
WARNING
Never operate the tractor with a loose wheel rim
or disc. Always tighten hardware to the specified
torque and at the recommended intervals.
Tractor wheels are very heavy. Handle with care
and ensure, when stored, that they cannot fall
and cause injury.
Spacing dimensions indicate the distance between
the center point of the tire tread.
Tractors can be equipped with two wheel drive (2
WD) or four wheel drive (FWD). (Note: 2WD not
available on the model 2210 tractor) Refer to the
appropriate heading for adjustment information.
WARNING
Your tractor is produced with lights that meet
lighting regulations when operating or traveling
on the public highway. If the wheel track setting
is adjusted beyond the initial factory position,
then you may be required to reposition the lights
or fit auxiliary lighting to comply with legal
requirements. Additionally, before traveling on
the highway, ensure that the overall tractor width
does not exceed the maximum permitted in your
locality.