Buhler 2180 - Manual (Page 193)

SECTION 3 - LUBRICATION AND MAINTENANCE
3-5
REMOVING THE ACCESS DOORS
The doors, 1, may be removed to provide improved
access.
To remove:
• Open the hood.
• Open the access door, 1, 25 mm (1″).
• Lift straight up on the door and slide the hinge
pins from the mount brackets.
4
HOOD
The hood is hinged at the rear to provide easy access
to the engine area. Two gas springs (located under
the hood) assist to raise the hood to either of two
positions.
The first position, 1, provides access for routine
maintenance except servicing the air cleaner.
The second position, 2, provides access to service
the air cleaner.
NOTE: The gas springs can be repositioned to adjust
the amount of force needed to open or close the
hood. Gas spring adjustment is covered in
“Operation 64” in this section of the manual.
5
OPENING THE HOOD
To Open the Hood to Position 1:
1. Open the left-hand access door
2. Push forward and up on the hood latch release
lever, 1, to unlock the hood.
3. Lift up on the handle, 2, until the gas springs raise
the hood to the first position.
6