Buhler 2180 - Manual (Page 241)

SECTION 3 - LUBRICATION AND MAINTENANCE
3-53
EVERY 1200 HOURS OR 12 MONTHS (WHICHEVER OCCURS FIRST)
Calibrate F1 Directional Clutch
To calibrate the low range directional clutch (F1):
1. Move the speed control lever to the forward
position.
2. Verify the display shows a flashing “CC.”
3. Move the speed control lever to the left and hold
it there.
NOTE: If wheel movement is detected, the LCD will
flash “F” (failed). Recheck parking brake engage-
ment and wheel blocks before restarting the
calibration procedure.
4. Observe the digital display. It will flash “20” for
approximately 4 seconds, then the number
displayed will increase by one digit every second
until the reading becomes steady. A steady
reading indicates that clutch F1 is calibrated.
5. Return the speed control lever to the neutral
position after the clutch is calibrated.
6. Verify that the digital display shows a flashing
“CC.”
93
Calibrate F2 Directional Clutch
To calibrate the high range directional clutch (F2):
1. Move the speed control lever to the forward
position.
2. Verify that the display shows a flashing “CC.”
3. Move the speed control lever to the right and hold
it there.
4. Observe the digital display. It will flash “20” for
approximately 4 seconds, then the number
displayed will increase by one digit every second
until the reading becomes steady. A steady
reading indicates that clutch F2 is calibrated.
5. Return the speed control lever to the neutral
position after the clutch is calibrated.
6. Verify that the digital display shown is flashing
“CC.”
94