Buhler 2180 - Manual (Page 30)

SECTION 1 - GENERAL INFORMATION
1-12
FORWARD OPERATOR CONTROLS
1. KEY-START/STOP SWITCH
The key start/stop rotary switch, 1, has four positions.
Position A - Accessories “ON,” Engine “OFF”
Position B - Engine and electrical equipment “OFF”
Position C - Warning lights and instruments “ON.”
Engine RUN position.
Position D - Starter motor operates
2. ENGINE SHUTDOWN OVERRIDE SWITCH
The two-position rocker switch, 2, allows the
operator to over ride the automatic shutdown. See
“Operating the Engine” for details on the automatic
shutdown feature. The switch should only be used to
move the tractor to a safe area for investigation and
repair. Push the top of the switch to override the
shutdown system. Push the bottom to return to
normal automatic shutdown operation.
3. CREEPER SWITCH (If Equipped)
The switch, 3, controls the engagement of the
creeper gears.
Push the top of the switch to select creeper. Push the
bottom of the switch to return to normal operation. Do
not select creeper unless the tractor has come to a
complete stop. See “Transmission Operation” for
details.
Tractors without creeper will have a blanking plate in
place of the switch.
19
4. STEERING COLUMN TILT CONTROL LEVER
Pulling on the lever, 4, allows the steering column to
be tilted up or down to a comfortable operating
position or out of the way for easy exit from the seat.
See “Cab” for details.
5. STEERING COLUMN TELESCOPIC ADJUST-
MENT CONTROL KNOB
Rotating the knob, 5, allows the steering column to be
shortened or lengthened to a comfortable operating
position. See “Cab” for details.
20