Buhler 2180 User Manual
Page 84
Advertising
SECTION 2 - OPERATION
2-38
EIC LIGHTING DISPLAY
EXITING THE SET UP MODE
To exit the operator calibration mode, touch the E/M
switch, 2. The display, 1, will show “ _ _ _1.” Touching
the switch again will return the display to normal
operation. Alternatively, to exit the set up mode, turn
the key-start switch off.
The EIC and Tractor Performance Monitor are now
programmed for use.
LIGHTING DISPLAY
The lighting display, 1, is used to activate and monitor
the dash and work light circuits.
The operation of the lighting display is covered under
the “Lighting and Accessory Power” heading.
59
60
Advertising