Buhler 2180 - Manual (Page 136)

SECTION 2 - OPERATION
2-90
FAST RAISE/WORK SWITCH
The FAST RAISE/WORK switch, 1, allows the
operator to rapidly raise the implement to the position
set by the height limit control and to lower the
implement back down to the position set by the lift
control lever, without disturbing these settings.
This feature allows the operator to raise the
implement at the headland and return the implement
to the same operating conditions.
To raise the implement, press the rear of the switch,
2. Press the front of the switch, 3, to lower the
implement to the work position.
To lower the hitch below the position set by the lift
control lever, without disturbing the settings, press
and hold the front of the switch, 4. When the switch
is released the hitch will return to the position set by
the lift control lever.
NOTE: The FAST RAISE/WORK switch should be
switched to the raise position when transporting
equipment.
The FAST RAISE/WORK switch is also used to
recapture the hitch after using the external fender
switches.
3
2
4
131
SLIP LIMIT CONTROL KNOB (If Equipped)
The slip limit control knob, 1, (if equipped) is in
addition to the optional radar sensor unit. It allows the
operator to select a wheel slip limit that when
exceeded overrides the electronic draft control
system. When the selected percent slip threshold
has been exceeded the hitch will raise until the wheel
slip is below the preset level. When the percent slip
is reduced below the threshold the hitch will return to
the preset operation. The slip override lamp, 2, is
illuminated whenever the slip exceeds the preset
threshold and remains on until the slip is reduced.
The knob is detented at the “Off” position (knob fully
clockwise). A digital display of wheel slip, and a slip
alarm may be programmed into the electronic
instrument cluster. See “Electronic Instrument
Cluster Programming”.
Slip limit control will also work in position control if the
tractor is equipped with load sensing pins.
NOTE: Slip limit control will not operate below 0.8 km
(0.5 mph) ground speed.
NOTE: Slip limit control will disengage when the
3-point hitch is raised with the fast raise switch or the
position control lever. The Slip limit control will
reengage after the 3-point hitch is lowered. The
implement must enter the ground and provide a
significant draft load to reengage the slip limit control
option.
1
2
132