Buhler 2180 - Manual (Page 166)

SECTION 2 - OPERATION
2-120
FWD STEERING STOPS
A steering stop is incorporated at each end of the
axle. The stops are adjustable and must be set to
provide a minimum clearance of 38 mm (1-1/2″)
between the tires or, if installed, fenders, and any part
of the tractor with the wheels turned full left and right
with the axle fully oscillated.
NOTE: If your tractor is equipped with optional front
fenders, ensure there is adequate clearance under
all operating conditions. Adjust the steering stops, as
necessary. Fenders will have to be removed for
1524 mm (60 ″ ) track spacing.
Adjust the steering stops at both ends of the axle to
the same turn angle.
To adjust the steering stop loosen jam nut, 1. Use a
wrench on the end of the threaded stop at, 2, and
thread the stop in or out so it will contact the fixed axle
stop, 3, when there is at least 38 mm (1-1/2”)
clearence between the tire and tractor as previously
described. Lock the jam nut, 1, to maintain the
adjustment.
Adjust the steering stop on the opposite side to the
same turn angle. Check that both stops are adjusted
to provide the specified clearence.
WARNING
Maintain all steering components in a reliable
and satisfactory condition to ensure safe
operation and comply with legal requirements.
3
1
2
179