Buhler 2180 User Manual
Page 305
5-33
OWNER COPY
DELIVERY REPORT/SERVICE
CHECK AND ADJUST AS REQUIRED
STATIONARY CHECKS -- ENGINE OFF:
_____1.
Tire pressures and condition
_____2.
Lift--rod adjusting blocks for proper operation
_____3.
Radiator coolant level and specific gravity
1.071 – 1.083 at 16° C (60° F)
_____4.
Poly V belt
_____5.
Engine oil level
_____6.
Drain diesel fuel filter and clean fuel
sedimenter
_____7.
Air Cleaner element and hose connections
_____8.
Coolant lines and clamps
_____9.
Windshield wiper washer and fluid
_____10. Transmission/rear axle oil level
_____11. Front axle differential oil level (FWD)
_____12. Front axle hub oil level (FWD)
_____13. Upper link, drawbar pins in position
_____14. Wheel disc--to--rim hardware torque
_____15. Wheel disc--to--hub hardware torque
_____16. Front end weight clamp bolts for tightness
_____17. Front end wheel toe--in & steering stops
_____18. Fuel level
_____19. Sheet metal and paint condition
_____20. Lubricate all grease fittings
_____21. Seat mounting and adjustment
_____22. Side console operation
_____23. Tilt telescopic steering column operation
_____24. Cab door and lock operation and seal
condition
_____25. Cab interior upholstery, trim and moldings
_____26. Cab window operation, gas springs, latches
and seal condition
_____27. Cab filter installation
_____28. All electrical cables, terminals and wires
_____29. Hood gas springs in proper mounting position
SAFETY ITEM CHECKS:
_____1.
Seat belt operation
_____ 2. Safety decals installed
_____ 3. All Safety shields installed
_____4.
Neutral start switches operative
_____5.
Parking brake operative
_____6.
Flashing lights/taillights operation
_____7.
Operator’s manual supplied
_____8.
SMV emblem installed
_____9.
Battery cables
STATIONARY CHECKS – ENGINE RUNNING:
All operative checks are to be performed with the tractor
at normal operating temperature:
_____1.
Lights and instruments for proper operation
_____2.
Fluid and oil leaks
_____3.
Maximum no--load speed and idle speed
adjustments and fuel shut--off
_____4.
PTO operation & brake
5. Hydraulic System
___ Selector lever & knobs for draft and position
control operation
___ Draft control operation
___ Remote control valves
___ Flow control operation
___ Pressure detent operation
_____6.
Transmission selector & EIC gear display
_____7.
Transmission clutch calibration
_____ F1_____ F2_____Rev
PERFORMANCE SERVICE CHECKS
_____1.
Dynomometer HP test, engine operation
including throttle and governor operation
_____2.
Transmission
_____3.
Steering control
_____4.
Differential lock and FWD engagement and
disengagement
_____5.
Brake action
_____6.
All optional equipment and accessories
___30--amp and 8--amp sockets
_____7.
Ballasting