Buhler 2180 - Manual (Page 83)

SECTION 2 - OPERATION
2-37
Fault codes, 1, will be flashing three-digit numbers
preceded by the letter “F.”
The fault code indicates the tractor circuit or sensor
in which the fault lies and the type of fault, e.g., short
circuit, open circuit, sensor failure, etc. If these codes
should occur, contact your authorized dealer and
quote the fault code number.
The modules and fault code ranges are as follows:
FAULT
CODE
NUMBER SYSTEM MODULE
F000-F099 Electronic Draft Control
F100-F199 Right-hand Controls
F200-F299 Electronic Instrument Cluster
F300-F399 Electronic Transmission Control
F400-F499 Engine
A complete detailed list of fault codes may be
seen at your Buhler Versatile dealer.
CLEARING FAULT CODES
During normal operation, when fault code “ON” is
selected, all fault codes will be displayed as they
occur and continue flashing until the fault is
corrected.
The code(s) can be temporarily cleared to return to
normal operation by holding the START/STOP
switch, 2, for three seconds. When the key switch is
turned to off and the tractor is restarted, the fault
code(s) will be redisplayed. Use the START/STOP
switch to again cancel the display of the fault codes.
Touch the SET UP/SELECT switch, 3, and the
display will cycle back to the first programming step
for review or further programming.
THREE POINT HITCH POSITION -- AREA
COUNTER
Used for setting the position of the 3-Point Hitch at
which the area counter stops accumulating. This
feature is used with a Three Point Hitch implement
where you wish to stop accumulating area with the
implement raised above a certain level. If used, set
the value of the flashing digit using the DIGIT SET
switch as described previously in this section. The
value may be set to any value from 00 (Three Point
Hitch at lowest point) to 99 (Three Point Hitch at
highest position). The setting must be 99 for the
remote implement status switch system to operate.
See area accumulator section found earlier in this
section.
57
58