Buhler 2180 User Manual
Page 165
SECTION 2 - OPERATION
2-119
Adjusting Toe-in - UltraSteer FWD Axle
To adjust the toe-in:
1. Park the tractor on level ground with front axle
steering straight ahead.
NOTE: Check that the center of the axle is aligned
with the center of the tractor before adjusting toe-in.
Turn angle will be affected if the axle is not centered.
NOTE: Before adjusting toe-in, measure the
distance, 1, between the outer, 2, and inner, 5, tie rod
ends on both tie rods. Adjust the tie rods to achieve
equal measurements before proceeding.
2. Loosen the two jam nuts, 3, on each tie rod.
3. Turn each tie rod tube, 4, evenly to adjust the
toe-in to 0 mm - 6 mm (0″ - 1/4″).
4. Tighten the two jam nuts, 3, on each tie rod.
5. Check the adjustment of the steering stops.
NOTE: Inspect the inner, 5, and outer, 2, tie rod ends
to make sure they are tight. If the tie rods appear
loose, contact your authorized dealer for assistance.
1
2
3
4
5
3
178