Buhler 2180 - Manual (Page 264)

SECTION 4 - TROUBLESHOOTING
4-2
FAULT CODES
A fault code indicates that there has been a
malfunction in the tractor electrical system. During
normal operation, the READ YOUR MANUAL
symbol, 1, will be displayed in the tractor
performance monitor (TPM) if a fault has occurred.
Fault codes can be retrieved and view using the
procedure detailed in “Electronic Instrument Cluster
- Operator Calibration” section.
Fault codes, 2, will be displayed as a flashing three
digit number preceded by the letter “F”. The code will
identify the circuit in which the malfunction has
occurred, along with the type of malfunction such as
short circuit, open circuit, etc.
The following chart identifies the system that
corresponds to the range of fault code numbers.
NOTE: Not all numbers in a range are used.
Contact your authorized dealer for assistance in
correcting a fault code.
FAULT CODE
NUMBERS SYSTEM
F000-F099 Electronic Draft Control
F100-F199 Right-hand Controls
F200-F299 Electronic Instrument
Cluster
F300-F399 Electronic Transmission
Control
F400-F499 Engine
70-550-358
2
------------------------------------------------------------------------------------------------------------------------------------------------
SYSTEM TROUBLESHOOTING
The following information lists possible problems, their cause and corrective action. The systems are listed as
follows:
ENGINE
TRANSMISSION
ELECTRICAL
HYDRAULIC 3-POINT HITCH
BRAKES
CAB