Buhler 2180 - Manual (Page 259)

SECTION 3 - LUBRICATION AND MAINTENANCE
3-71
GENERAL MAINTENANCE
OPERATION 68
REPLACE HEADLIGHT ASSEMBLY BULBS
IMPORTANT: All headlights have halogen bulbs.
Never touch a halogen bulb with your fingers. Natural
oil in the skin may cause the bulb to fail prematurely.
Always use a clean cloth or tissue when handling
halogen bulbs.
To replace a bulb:
1. Disconnect the wire harness connector, 1, from
the bulb assembly, 2.
2. Rotate the bulb assembly, 2, counterclockwise
until it disengages from the housing, 3.
3. Remove the bulb assembly.
4. Install the new bulb assembly in the housing.
5. Rotate clockwise until the bulb assembly locks in
the housing.
6. Connect the wire harness connector.
7. If more than one bulb assembly was replaced,
check operation of lights with light switch to
ensure harness was reconnected correctly.
122
OPERATION 69
REPLACE WORK SEALED BEAM UNITS
1. Remove the retaining screws, 1.
2. Pull the beam unit, 2, from the case, 3.
3. Disconnect the connectors, 4.
4. Connect the new beam unit to the connectors.
5. Install the new beam unit into the case.
6. Install the retaining screws.
123