Buhler 2180 - Manual (Page 70)

SECTION 2 - OPERATION
2-24
SELECTABLE DISPLAYS
Using the key pad, the lower display will allow the
operator to select one of three displays as follows:
Engine Hour Meter
When the KEY-START switch is turned on, the LCD
will display the hours the engine has operated, 1, and
the hour meter symbol, 2.
The operator may manually select ground speed or
PTO speed. Driving the tractor will cause the display
to change automatically to ground speed. The hour
meter display may be recalled at any time by
touching switch, 3, Figure 35.
With the engine running, the hour meter will
accumulate hours in increments of 0.1 hours until
1999.9 hours are reached. After that time, the hour
meter will accumulate complete hours only, e.g.
2000, 2001 hours, etc.
NOTE: Accumulated hours are stored in the
computer permanent memory which is not affected
by disconnecting the tractor batteries.
The hour meter may be programmed to remind the
operator when the next scheduled service is due.
When a Service Alert is reached, the word
“SERVICE”, 3, will flash along with the selected
display. See “Programming the Service Alert
Indicators” later in this section.
34