Buhler 2180 - Manual (Page 133)

SECTION 2 - OPERATION
2-87
CONTROLS
The electro-hydraulic three-point hitch control
system is operated from a console to the right of the
operator’s seat. The console houses:
1. Lift control lever
2. Position/draft sensitivity control knob (if equipped)
3. Drop rate control knob
4. Height limit control knob
5. Slip limit control knob (if equipped)
2
1
4 3
5
126
LIFT CONTROL LEVER
The lift control lever, 1, controls implement height or
working depth in position control and draft loading in
draft control. Pull the lever rearward to raise the
3-point lift, and push forward to lower in position
control. In draft control moving the lever forward
increases the load demanded from the hitch and
moving the lever rearward decreases the load
demanded.
An adjustable lift control lever stop, 2, is located to the
right of the lift lever. The stop sets the lower or upper
travel of the lift lever. To adjust, loosen the stop knob
and slide the stop forward or rearwards to contact the
lift lever in the desired position. Tighten the stop
knob.
The stop should be placed in front of the lever when
transporting implements.
127