Buhler 2180 - Manual (Page 76)

SECTION 2 - OPERATION
2-30
Battery Voltage
Touch the SET UP/SELECT switch, 3. The “VOLTS”
legend, 1, will display, together with a digital display
of battery voltage, 2, to the nearest tenth volt.
41
PTO Speed 540 RPM Scale (If Equipped)
Touch the SET UP/SELECT switch, 4, again and the
“540 PTO” legend, 1, will be displayed, together with
a digital display of PTO speed, 2. This feature allows
the operator to view both PTO speed and ground
speed while operating.
PTO Speed 1000 RPM Scale
Touch the SET UP/SELECT switch, 4, again and the
“1000 PTO” legend, 3, will be displayed, together
with a digital display of PTO speed, 2. This feature
allows the operator to view both PTO speed and
ground speed while operating.
42
Distance Measurement
Touch the SET UP/SELECT switch, 6 again and the
“DIST FT”, 1, or “DIST METERS” legend will be
displayed. The tractor will now measure distance in
feet or meters. Operate the tractor normally and
press the START/STOP switch, 5, at the point where
distance measuring is to begin. The “ON” legend, 2,
will be displayed along with a digital display of
distance traveled, 3. At the end of the distance, again
press the START/STOP switch, 5. A digital display of
distance traveled in feet or meters will be displayed
with the “OFF” legend, 4. If the START/STOP switch
is again pressed, additional feet or meters will be
added to the existing measurement. Pressing the
START/STOP switch, 5, for more than three seconds
will zero the display.
43