Buhler 2180 User Manual
Page 261
Advertising
SECTION 3 - LUBRICATION AND MAINTENANCE
3-73
GENERAL MAINTENANCE
OPERATION 72
ELECTRONIC INSTRUMENT CLUSTER
(EIC) BULB REPLACEMENT
To replace a bulb:
1. Loosen the two retaining screws, 1, then pull the
EIC away from the dash.
126
2. Disconnect the electrical connector, 1, and
ground wire, 2, from the rear of the EIC.
3. Remove the rear cover retaining screws, 3, and
remove the rear cover.
127
4. Remove the failed bulb assembly, 1, by rotating
1/4 turn counterclockwise with a small screwdriv-
er. Install a new bulb.
5. Reinstall the rear cover.
6. Install the electrical connector and ground wire.
7. Install the EIC in the dash and tighten the two
retaining screws.
128
Advertising