Buhler 2180 - Manual (Page 252)

SECTION 3 - LUBRICATION AND MAINTENANCE
3-64
3. Put RAISE/WORK switch, 1, in work position, 3.
(2 = Raise position, 3 = Work position, 4 = lower
position)
4. Start the tractor with the parking brake applied.
5. Move the quadrant lever fully forward.
6. Check lift cylinders for exposed chrome. If
chrome is visible, use fender switches to lower
3-point until cylinders are fully retracted.
NOTE: The RAISE/WORK switch must be cycled to
the raise position then work position before the
quadrant lever will capture the hitch and allow you to
proceed.
7. Slowly move quadrant lever rearward to full up
position, which captures the hitch and raises it to
the top of its range.
NOTE: Steps 1-7 allow the modules to establish the
limits of the rockshaft and quadrant sensors, (0-99).
3
2
4
109
EDC Valve Calibration
1. To calibrate the 3-point hitch valve select mode
11 by:
a. holding the set up select switch, 1,
(approximately 3 seconds) until a “beep” is
head from the alarm. The TPM display will
indicate --- 1, 2, which means the EIC is at
mode 1.
110
b. using the “DIGIT SET” switch, 1, (up arrow)
advance to mode 11.
c. enter mode 11 by holding the SET/UP
SELECT switch, 2, (approximately 3 sec-
onds) until a “beep” is heard.
1 2
111