Lenze ECSCExxx Power supply module - Manual (Page 10)

Preface and general information
Terminology used
1
l
10 EDBCSXE040 EN 7.0
1.2 Terminology used
Term In the following text used for
Power supply module
Standard device ECSxE... power supply module
ECSxE...
Capacitor module ECSxK series capacitor module
ECSxK...
Axis module
Controller Axis module of the ECS series:
l ECSxS... − "Speed and Torque"
l ECSxP... − "Posi and Shaft"
l ECSxM... − "Motion"
l ECSxA... − "Application"
ECSxS...
ECSxP...
ECSxM...
ECSxA ...
Drive system ECS drive system consisting of:
l ECSxE... power supply module
l Axis modules ECSxS... / ECSxP... / ECSxM... / ECSxA...
l ECSxK series capacitor module (optional)
l further Lenze drive components (accessories)
24 V supply
Low−voltage supply Voltage supply of the control card, voltage range 20 ... 30 V DC ( ±0 V)
AIF Automation InterFace
System bus (CAN) A Lenze standard bus system based on CANopen for
l communication with a higher−level host system (PLC) or further controllers.
l parameter setting and diagnostics.
MotionBus (CAN) The "MotionBus (CAN)" term expresses the functionality of the CAN interface X4 for
the axis modules ECSxS/P/M.... In case of these devices, communication takes place
with a higher−level master system (PLC) or further controllers exclusively via the
interface X4. Parameter setting and diagnostics are exclusively carried out via
interface X14 (CAN−AUX).
GDC Global Drive Control
(Lenze software for parameter setting and diagnostics)
Cxxxx Code Cxxxx (e.g. C0351)
Parameter for parameterising or monitoring the controller.
Cxxxx/y Subcode y of code Cxxxx (e. g. C0470/3 = subcode 3 of code C0470)
Xk/y Terminal y on plug connector Xk (e. g. X6/B+ = terminal B+ on plug connector X6)