Lenze ECSCExxx Power supply module User Manual
Page 15
Safety instructions
General safety and application notes for Lenze power supply modules
l
15
EDBCSXE040 EN 7.0
Application as directed
Power supply modules are components which are designed for installation in electrical
systems or machinery. They are not to be used as domestic appliances, but only for
industrial purposes according to EN 61000−3−2.
When installing the power supply modules in machines, commissioning (i.e. starting of
operation as directed) is prohibited until it is proven that the machine complies with the
regulations of the EC Directive 2006/42/EC (Machinery Directive); EN 60204 must be
observed.
Commissioning (i.e. starting of operation as directed) is only allowed when there is
compliance with the EMC Directive (2004/108/EC).
The power supply modules meet the requirements of the Low−Voltage Directive
2006/95/EC. The harmonised standard EN 61800−5−1 applies to the power supply
modules.
The technical data as well as the supply conditions can be obtained from the nameplate
and the documentation. They must be strictly observed.
Warning: The power supply modules are products which can be installed in drive systems
of category C2 according to EN 61800−3. These products can cause radio interference in
residential areas. In this case, special measures can be necessary.
Transport, storage
Please observe the notes on transport, storage, and appropriate handling.
Observe the climatic conditions according to the technical data.
Installation
The power supply modules must be installed and cooled according to the instructions
given in the corresponding documentation.
The ambient air must not exceed the degree of pollution 2 according to EN 61800−5−1.
Ensure proper handling and avoid excessive mechanical stress. Do not bend any
components and do not change any insulation distances during transport or handling. Do
not touch any electronic components and contacts.
Power supply modules contain electrostatically sensitive components which can easily be
damaged by inappropriate handling. Do not damage or destroy any electrical components
since this might endanger your health!