Lenze ECSCExxx Power supply module - Manual (Page 85)

Configuring system bus (CAN)
Setting the CAN node address and baud rate
Settings via codes
8
l
85 EDBCSXE040 EN 7.0
Save changes with C0003 = 1.
The settings are only accepted after carrying out one of the following actions:
ƒ Renewed switch−on of the 24 V low−voltage supply
ƒ Reset node via the bus system (by the network management (NMT))
ƒ Reset node with C0358 = 1
)
Note!
If reset node is executed via GDC, communication will be interrupted. You
therefore have to log in again manually or find the devices connected to the
bus once again (fieldbus scan).