Lenze ECSCExxx Power supply module - Manual (Page 89)

Configuring system bus (CAN)
Setting the mode for process data transfer
8
l
89 EDBCSXE040 EN 7.0
8.4 Setting the mode for process data transfer
The process data can be transmitted cyclically (sync−controlled, ^ 156) via CAN1_IN/OUT
or event−controlled/cyclically without sync (
^ 157) via CAN3_IN/OUT.
The configuration is carried out via C0360.
Parameter
C0360
Designation
CAN PDOs/mode selection
Data type: INTEGER_32
Index: 24215
dec
= 5E97
hex
Selection of CAN PDOs/mode for the process data transfer via the system bus (CAN)
^ 89
Selection list
(Lenze setting printed in bold) Information
0 No response event−controlled/cyclic without sync
1 CAN1_IN/OUT cyclic (sync−controlled)